On the 5th day of Geekmas, I printed this Sword Dice Holder from D&D. There was little to no post processing on this one. It just needed to be assembled, and little bit of gloop. This print is a nice break from the other prints of Geekmas as it's relatively easy to print with a high satisfaction upside. My only recommendation on this one would be to use tree supports on the blade.

You can see this one over on TikTok:

@geekyinc

Day 5 of Geekmas brings us this legendary D&D short sword! Comment below if you'd like the link to print. #geekmas #geek #geekculture #dungeonsanddragons #shortsword

♬ original sound - geekyinc

The breakdown:

💡
Geeky Inc Category - Tabletop Gaming and Gaming
Original Appearance - Dungeons and Dragons
Time to Print (on a Bambu P1P) ~ 8 hours
Post Processing - Minor
Link to STL - https://www.printables.com/model/76474-freds-dice-dagger

Wave 1 — Kitsune Legends Vol. 1

Get notified when Wave 1 drops.

Limited run of articulated 3D printed figures. Anime × JRPG aesthetic. Blind box format. 20 chase units.

Join the waitlist →